Non-explosion-proof electronic device heaters GTG-PBK-70/PROM are used to warm up electronic control units, on-board computers, and systems and components requiring spot heating. The operating temperature of the heating element prevents overheating of electronic components.

Electronic device heaters are equipped with a temperature control device that prevents the plate heating temperature from exceeding 70°C, which ensures guaranteed safety of use.

Electronic device heaters GTG-PBK-70/PROM are resistant to friction and aggressive environments such as oil, gasoline, salt, etc.

Electronic device heaters are simple and easy to install. Simply remove the protective layer from the heater and adhere it to the desired, pre-cleaned and degreased surface. The heater's power wires are routed within the existing wiring harnesses. GTG-PBK-70/PROM electronic device heaters are connected through a fuse. It is recommended to switch the heater off when starting the engine or when parked for long periods.

When selecting an electronic device heater, consider the size of the heater and the intended installation location. The heater is designed for long-term warm-ups. The GTG-PBK-70/PROM electronic device heater can be connected directly to the battery. However, please note that if the battery is not being recharged, using this connection type may result in its complete discharge. To determine battery discharge time, use the following formula: Amps x Hours = Amps. For example, a 0.67 A heater will completely discharge a 100 A/h battery in 150 hours. (100 A/h : 0.67 A = 150 hours).

Non-explosion-proof heaters for electronic devices GTG-PBK-70/PROM CANNOT be used for heating batteries and fuel!

• High efficiency.
• Long service life.
• Quick warm-up.
• Designed for use during long warm-ups
• The plates are simple and easy to install.
• Equipped with a temperature control device
• Easy installation.